Delta Ditch Run at Stockton Sailing Club/Richmond Yacht ClubJune 2
Story
Norcalsailing report featuring Summer Palace:
http://www.norcalsailing.com/entries/2012/06/05/ditchrun2.html#.T-iWoI2Mfqs

Below quoted from Pressure Drop: Drew Scott was helming a F-28.

"My crew is starting to swing around to pick me up when El Raton, in perfect control slides up beside me and asks if I would like to get picked up. They had already doused their chute and stopped beside me. I took their offer and got back into a boat (trying to stop a lightweight trimaran next to someone when it is blowing in the mid-20s is not easy so I figured I would not turn down El Raton.

My crew ably finished the race on Papillon, only one boat behind El Raton! And I had many adventures with El Raton, but that is their story to tell.

So, a great big thank you to the Ray Lotto and the crew of El Raton for pulling my soggy hide out of Suisun Bay!!

Drew Scott
Papillon (most of the time)"
Result
PosBoatTotalRace 1
1El Raton11
2Magic Bus22
3Peaches33
4Scandalous44
5Wile E Coyote55
6Loose Cannon66
7Take Five77
8Ergo88
9Great White99
10Libra1010
11Summer Palace1111
export csv

Regatta Message Board

Reply | Post New Message | All Messages | this message is spam
Author: Will Paxton ([email protected]) contact the author
Subject: Stanchion removal
Info: (21362 views) Posted: Friday 3-31-06 08:04:31 AM
Andy, The best thing to do is to mark them at the deck and then measure to the top. That way you can just measure from the mark down once they are out to subtract the correct length. Sometimes stantions have set screws thru the socket down below that must be removed first. Once the wire has been removed from the stantion top you can insert a large round shaft screw driver to twist and lift the stantion out if it is being stubborn. If its really stuck you can hit the screw driver upwards with a rubber mallet to break it loose. Call me if you need any more help. Will 510-508-7231

:: What is the best method of removing stanchions to
:: shorten them to the minimum height?

:: Thanks

:: Andy

Reply | Post New Message | All Messages | this message is spam