$163 for a standard set which Buzz said fits most Expresses. These
did not fit my hull#100. Inside diameters to0 tight and I believe
upper bearing was too tall.
$75 dollars to recut them to my specs that I measured with a caliper.
This is my second set of bearings. First new ones lasted about 9
years. 1st time I took the rudder to Buzz to measure rudder post. All
fit well except the upper bearing was too tall, so I shaved that down
myself since height tolerance is not absolutely critical on the
upper.
Any excessive up and down movement will wear the bearing out, so Buzz
provided for few upper washers in different thicknesses.
My first set, I sealed in the lower with some 3M 4200, but not the
5200 stuff (others reported hard to remove later). The 4200 adhesion
did not last despite a good prep and repeated application a few years
later. I believe there is not much for the adhesive to grab onto
except the top of edge of the lower bearing. I used silicone to hold
in place the upper bearing.
This second set I did not use any adhesive since the outside
diameters are pretty snug.
I would like to hear from others about about sealing the bearings.
Joe B.
:: What is the cost of the bearing as i am sure i could use
:: a set
:: chris
::
::
:: :: I need new rudder bearings. Called Buzz Ballenger and
:: :: said he will make new one if he gets a minimum order for
:: :: five sets.
:: ::
:: :: I placed an order. Need four more. Anyone else need a
:: :: set?
:: ::
:: :: Call Buzz Ballenger 831) 763-1196.