Elite Keel at San Francisco Yacht ClubMay 18 - 19
Story
Congratulations to Dianne with their win in the Elite Keel Regatta.
Here is Steve's Top Ten List that he has submitted for publication.

ELITE KEEL STORY-A LIST OF TEN THINGS THAT HELPED DIANNE

1) The crew: Jarian Westfall, Laurel Schmidt, Mike Pastrone, Jeff Fellicetti

2) Will Paxton wasn't there.

3) This crew can change head sails, the hanked kind, in less then 2.3 minutes.

4) Wilie E Coyote didn't race Sunday.

5) Sun was shining.

6) It was my birthday weekend.

7. El Raton wasn't there.

8. We went left when we could.

9. The wind was blowing.

10. This crew has 59 combined years sailing with me.
Result
PosBoatTotalRace 1Race 2Race 3Race 4Race 5
1Dianne113(3)2(5)2(7)1(8)3 (11)
2Peaches154(4)4(8)4(12)2(14)1 (15)
3Motorcycle Irene161(1)1(2)3(5)6(11)5 (16)
4Summer Palace247(7)6(13)5(18)4(22)2 (24)
5Abigail Morgan255(5)3(8)6(14)5(19)6 (25)
6Strega308(8)8(16)7(23)3(26)4 (30)
7Wile E Coyote322(2)5(7)1(8)DNS(20)DNS (32)
8Libra449(9)7(16)9(25)DNF(37)7 (44)
9Make Me Smile516(6)9(15)DNF(27)DNS(39)DNS (51)
10Moonlight5210(10)10(20)8(28)DNF(40)DNS (52)
11Elise60DNC(12)DNC(24)DNC(36)DNC(48)DNC(60)
export csv

Regatta Message Board

Replying to this message
Reply | Post New Message | All Messages | this message is spam
Author: Ralph Deeds ([email protected]) contact the author
Subject: Mast step fiberglass compression issues
Info: (27783 views) Posted: Tuesday 11-10-09 08:05:48 PM
:: The fiberglass beneath my mast step has a few cracks and
:: maybe even a bit of compression from it's normal
:: thickness.
::
:: Anybody else noticed this on their boats? What can be
:: done about it?

Our boat repair guru in Detroit, Tim Sarns, told me that he has repaired several boats (not E27s) with compression under the mast step by removing the step and the deck skin under it; removing the bad core under it and epoxying a thick aluminum plate under the mast step plate. The aluminum plate should be a fair amount wider and longer than the mast step plate in order to spread the compression load. Once the aluminum plate is in place the area above it can be filled and faired and a new fiberglass cloth epoxied in on top of the aluminum plate and faired. Then the deck plate can be re-installed. As already mentioned, any problems below with the bulkheads or the wood cross beam or ash A-frame mast support should be addressed also.

Reply | Post New Message | All Messages | this message is spam

Your Name
Your E-Mail (optional)
Subject
Password (optional - allows you to delete later)