Elite Keel at San Francisco Yacht Club | May 18 - 19 |
Story |
Congratulations to Dianne with their win in the Elite Keel Regatta.
Here is Steve's Top Ten List that he has submitted for publication. ELITE KEEL STORY-A LIST OF TEN THINGS THAT HELPED DIANNE 1) The crew: Jarian Westfall, Laurel Schmidt, Mike Pastrone, Jeff Fellicetti 2) Will Paxton wasn't there. 3) This crew can change head sails, the hanked kind, in less then 2.3 minutes. 4) Wilie E Coyote didn't race Sunday. 5) Sun was shining. 6) It was my birthday weekend. 7. El Raton wasn't there. 8. We went left when we could. 9. The wind was blowing. 10. This crew has 59 combined years sailing with me. |
Result | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Regatta Message Board |
Reply | Post New Message | All Messages | this message is spam |
Author: Jason Subject: Jib Halyard Sheave Trouble Info: (12738 views) Posted: Thursday 12-27-07 09:20:54 PM |
-Jason
:: Jason,
::
:: On Magic, the Jib halyard currently exits the mast below
:: the forestay pin. Above the forestay pin are two sheaves
:: that are occupied by the #1 spin halyard and the #2 spin
:: halyard. Should we remove the old #2 spin halyard and
:: use that for our jib halyard and not worry about the
:: "original sheave"?
::
:: :: Mike,
:: ::
:: :: Sounds like you still have the original sheaves in the
:: :: mast. You want to give Ballanger spars a call and have a
:: :: couple new ones sent to you. The original ones are for
:: :: wire halyards and will start eating up your nice
:: :: high-tech halyards.
:: ::
:: :: To answer your question though, you are probably going
:: :: to want to drop the mast to replace them. Both halyards
:: :: and the forestay ride on the same pin. So, to replace
:: :: the sheave you need to remove the shaft (pin) that goes
:: :: through both sheaves and the forestay eye. It can be
:: :: tricky to thread the needle through all three items with
:: :: the mast down, with the mast up would be very
:: :: interesting. I suppose it could be done if you held the
:: :: mast in place with the topping lift, but I would not
:: :: recommend it.
:: ::
:: :: One hint, when installing the new shives make sure you
:: :: use a small piece of line looped around the groove of
:: :: the sheave, as if it were a halyard running around the
:: :: sheave. If you don't you will likely drop the sheave
:: :: inside the mast and spend several hours trying to fish
:: :: it out of the mast. Ask me how I know this!
:: ::
:: :: Cheers,
::
:: :: Jason
:: ::
:: :: :: Our jib halyard sheave is very hard to turn. The sheave
:: :: :: appears to be intact, but is showing metal fillings on
:: :: :: both side as if it is not seated properly, although it
:: :: :: looks square to the mast top halyard entrance. How do I
:: :: :: take it apart to replace it? DO I need to drop the
:: :: :: Mast???
:: :: ::
:: :: :: Mike
:: ::
:: :: :: #80
:: ::
:: :: :: Magic
Reply | Post New Message | All Messages | this message is spam |