Berkeley Mid Winter #4 at Berkeley Yacht ClubFebruary 9
Result
PosBoatTotalRace 1
1Dan Pruzan Wile E Coyote11
2Motorcycle Irene22
3Bessie Jay33
4Freaks ona Leash44
5Mirage55
6Libra66
7Dianne77
8Wetsu88
9Take Five99
10Elise1010
11Abigail Morgan1111
12Strega1212
14Great White14DNC
14Opa!14DNC
14Peaches14DNC
14Eagle14DNC
14Magic Bus14DNC
export csv

Regatta Message Board

Reply | Post New Message | All Messages | this message is spam
Author: Jason ([email protected]) contact the author
Subject: Cradle support positions?
Info: (22901 views) Posted: Friday 3-30-07 05:22:13 PM
John,

One thing I have done that worked well was to just place large pieces of dock styrofoam on top of the existing pads. Make sure they are all about the same size then place them on the pads. When you hoist the boat out of the water just place it on the blocks and you will now have about a foot underneath the keel. I wouldn't drive the boat too far but will certainly work sitting at the club.

-Jason

:: I want to build a cradle with two fiberglass shoes to
:: support the hull while the keel hangs above the ground
:: in order to repair some sounding damage.

:: I'm looking for suggestions as to the best location for
:: the aft shoe.
::
:: I'm guessing the forward shoe should probably be under
:: the mast support bulkhead - between the keel and depth
:: sounder. But aft of the keel there isn't much structure
:: inside the hull until the semi-bulkhead under the aft
:: end of the cockpit which is 13' from the forward shoe.
:: I'd like to make the cradle collapsible, like a builders
:: scaffold, and smaller than 13' long. Do you think a
:: fitted shoe say 9' back from the forward bulkhead would
:: provide adequate support for the hull?

Reply | Post New Message | All Messages | this message is spam