Delta Ditch Run at Stockton Sailing Club/Richmond Yacht ClubJune 2
Story
Norcalsailing report featuring Summer Palace:
http://www.norcalsailing.com/entries/2012/06/05/ditchrun2.html#.T-iWoI2Mfqs

Below quoted from Pressure Drop: Drew Scott was helming a F-28.

"My crew is starting to swing around to pick me up when El Raton, in perfect control slides up beside me and asks if I would like to get picked up. They had already doused their chute and stopped beside me. I took their offer and got back into a boat (trying to stop a lightweight trimaran next to someone when it is blowing in the mid-20s is not easy so I figured I would not turn down El Raton.

My crew ably finished the race on Papillon, only one boat behind El Raton! And I had many adventures with El Raton, but that is their story to tell.

So, a great big thank you to the Ray Lotto and the crew of El Raton for pulling my soggy hide out of Suisun Bay!!

Drew Scott
Papillon (most of the time)"
Result
PosBoatTotalRace 1
1El Raton11
2Magic Bus22
3Peaches33
4Scandalous44
5Wile E Coyote55
6Loose Cannon66
7Take Five77
8Ergo88
9Great White99
10Libra1010
11Summer Palace1111
export csv

Regatta Message Board

Reply | Post New Message | All Messages | this message is spam
Author: Ralph Deeds ([email protected]) contact the author
Subject: Spreader Bars
Info: (28850 views) Posted: Tuesday 2-12-08 12:57:49 PM
Dan, If you look around, you can get just about anything you need fabricated in Detroit. But it might cost you a bit more. I bet Todd Jones could point you toward somebody who could make one for you.

:: So it looks like I can't get a new bar made and there
:: are no used ones out there.

:: What would be the best and safest way to heat and
:: bending the bar back into shape with out compromising
:: the strength of the aluminum?
::
::
:: :: I have a set of the upper spreaders for you Dan. I do
:: :: not have the connecting bar between the spreaders
:: :: though. The spreaders themselves are in decent shape. If
:: :: you want them just let me know. You pay for shipping and
:: :: they are yours.
:: :: 

:: :: -Jason
:: ::
:: :: :: I'm looking to replace our upper spreader bars. They
:: :: :: have been bent back and forth a few times and drop a
:: :: :: bit.
:: ::
:: :: :: Anyone have an extra set for sale or know where to get
:: :: :: them made?
:: ::
:: :: :: Thanks,
:: ::
:: :: :: Dan
Reply | Post New Message | All Messages | this message is spam