Delta Ditch Run at Stockton Sailing Club/Richmond Yacht ClubJune 2
Story
Norcalsailing report featuring Summer Palace:
http://www.norcalsailing.com/entries/2012/06/05/ditchrun2.html#.T-iWoI2Mfqs

Below quoted from Pressure Drop: Drew Scott was helming a F-28.

"My crew is starting to swing around to pick me up when El Raton, in perfect control slides up beside me and asks if I would like to get picked up. They had already doused their chute and stopped beside me. I took their offer and got back into a boat (trying to stop a lightweight trimaran next to someone when it is blowing in the mid-20s is not easy so I figured I would not turn down El Raton.

My crew ably finished the race on Papillon, only one boat behind El Raton! And I had many adventures with El Raton, but that is their story to tell.

So, a great big thank you to the Ray Lotto and the crew of El Raton for pulling my soggy hide out of Suisun Bay!!

Drew Scott
Papillon (most of the time)"
Result
PosBoatTotalRace 1
1El Raton11
2Magic Bus22
3Peaches33
4Scandalous44
5Wile E Coyote55
6Loose Cannon66
7Take Five77
8Ergo88
9Great White99
10Libra1010
11Summer Palace1111
export csv

Regatta Message Board

Reply | Post New Message | All Messages | this message is spam
Author: George Macon
Subject: Running rigging replacement
Info: (12803 views) Posted: Sunday 12-4-05 12:05:09 PM
Having sailed w/ Ralph for a while this summer, I can verify that the thinner sheets are excellent in ALL wind conditions. The sheets ran VERY easy and did not hang up the sail in light air. In heavy air, the line weight was more than adequate. I can't see a reason for anything heavier the 5/16ths, gloves or no gloves.

:: For jib and genoa sheets I use 5/16ths Samson WarpSpeed.
:: Last year I moved down a size on the theory that the
:: genoa would tack faster and better with smaller
:: diameter, lighter sheets. I'm very happy with the
:: results and would never go back to 38ths. Perhaps
:: surprisingly, nobody has complained about the smaller
:: diameter sheets being hard on their hands and several of
:: them don't use gloves.
::
:: For main and jib halyards, I had Thomas Hardware make up
:: some low-stretch rope halyards with covers at the
:: bottom. I don't remember what kind of rope it is.
:: However, you have to keep checking the top end for chafe
:: where the halyard comes out of the sheave. I've had to
:: cut a few inches off the top end of my main halyard
:: after a year or so due to chafe.

Reply | Post New Message | All Messages | this message is spam