Delta Ditch Run at Stockton Sailing Club/Richmond Yacht ClubJune 2
Story
Norcalsailing report featuring Summer Palace:
http://www.norcalsailing.com/entries/2012/06/05/ditchrun2.html#.T-iWoI2Mfqs

Below quoted from Pressure Drop: Drew Scott was helming a F-28.

"My crew is starting to swing around to pick me up when El Raton, in perfect control slides up beside me and asks if I would like to get picked up. They had already doused their chute and stopped beside me. I took their offer and got back into a boat (trying to stop a lightweight trimaran next to someone when it is blowing in the mid-20s is not easy so I figured I would not turn down El Raton.

My crew ably finished the race on Papillon, only one boat behind El Raton! And I had many adventures with El Raton, but that is their story to tell.

So, a great big thank you to the Ray Lotto and the crew of El Raton for pulling my soggy hide out of Suisun Bay!!

Drew Scott
Papillon (most of the time)"
Result
PosBoatTotalRace 1
1El Raton11
2Magic Bus22
3Peaches33
4Scandalous44
5Wile E Coyote55
6Loose Cannon66
7Take Five77
8Ergo88
9Great White99
10Libra1010
11Summer Palace1111
export csv

Regatta Message Board

Reply | Post New Message | All Messages | this message is spam
Author: Jason Crowson ([email protected]) contact the author
Subject: Rudder Bearings
Info: (20800 views) Posted: Friday 1-30-15 04:10:18 PM
I would be careful as not all rudder shafts and bearing supports are the same size. Off by a few mm will make a big difference. Make sure you measure each one and double check the sizes. I have had a couple pair made in the past (not by Buzz) so there are plenty of places that can make these.

Just my $.02

Cheers, Jason

:: I need new rudder bearings. Called Buzz Ballenger and
:: said he will make new one if he gets a minimum order for
:: five sets.
::
:: I placed an order. Need four more. Anyone else need a
:: set?
::
:: Call Buzz Ballenger 831) 763-1196.

Reply | Post New Message | All Messages | this message is spam