Doublehanded Farallones at BAMAMarch 31
Result
PosBoatTotalRace 1
1El Raton2DNF
2Dianne8DNS
3Wetsu8DNS
4Elise8DNS
5Verve8DNS
6Chile Dog8DNS
7Ranger8DNS
export csv

Regatta Message Board

Reply | Post New Message | All Messages | this message is spam
Author: Tom Jenkins
Subject: Pipe Berth Repair
Info: (14728 views) Posted: Tuesday 6-23-09 04:53:26 PM
Dan- If it were anyone else, I would say use a 1/2" bolt with lock nut clear thru the boats hull, the drag won’t hurt too badly. In all seriousness, what Jason says is the same way I fixed mine, I would however use stainless steel so that the aluminum can not corrode inside the hull even if it does get totally sealed up it is likely to corrode over time which could cause a small blister from the expansion of the metal and corrosion.

:: A couple of the rivets that secure the metal rail of the
:: pipe berth to the hull have failed. Any suggestions for
:: the best way to remedy this?
::
:: Thanks
::
:: Dan

Reply | Post New Message | All Messages | this message is spam