We had problems pulling the washers into the glass/core under the
deck. I highly suggest using some type of backing plate. We use a
high density plastic sheeting material that seems to be working. The
thought was to use something strong and light, but with a little bit
of flex so we wouldn't point load the edges of the backing plate.
I just purchased new Torlon Ball Bearings for our car. It's scheduled
as my Father's Day project. Since it's the older style, I called
Harken and they said it's tedius, but the balls can be replaced with
the car still on the track -- open one end, heel the boat towards the
other and one by one load the balls. I've been told the last couple
you can use a dab of shaving cream to hold them in place while you
re-attach the end cap. Also told to make sure to have a bucket
underneath to catch the ones you drop.
Good luck.
:: The traveler should be through-bolted. The bolts should
:: pass through the wood and have nuts & washers on the
:: inside of the boat. This whole system takes quite a bit
:: of load...
::
:: Unfortunately, removing & reinstalling the traveler is a
:: bit of a job and may require two people. Plus, the
:: screws through the seats go through balsa-cored deck and
:: should be sealed well when re-installed.
::
:: It is much easier to replace the bearings if you have a
:: plastic bearing loader from Harken. These come with the
:: travelers when they are new. Otherwise, folks use
:: shaving cream to hold the bearings in place while you
:: stuff them in, and wash it out after full assembly.
::
:: Good luck,
:: --brendan
::
:: :: I have a windward sheet traveler and it appears that it
:: :: is starting to lose the ball bearings. Lots of sloppy
:: :: play and I can see the top cleats are losing the bearing
:: :: also.
:: ::
:: :: I want to repair or replace it. My question is .. Are
:: :: the screws / bolts supporting this driller through the
:: :: deck or is it just in the wood? Just trying to find out
:: :: before I remove the track to remove the car.
:: ::
:: :: thanks,
::
:: :: Don
