Reply | Post New Message | All Messages | this message is spam
Author: Paul Cronin (paulcroninstud...@gmail.com) contact the author
Subject: Help with leaky chain plates
Info: (17985 views) Posted: Monday 5-12-14 08:16:51 PM
Cut the top skin an replace the core. I just did this to both sides but much bigger areas and the mast step area. You could cut the skin, remove the wet core an bag in the new core in the same day, actually 90 min. Then 4 he's later fair it in an hour an put the top skin on bagged again. Then roll gel coat for a texture match. Easy job for such a small area. And you should use a quality vinylester resin.

Are you talking about putting epoxy in the chainplate holes? If so I would not do that.

:: I know one of the chain plates was starting to leak and
:: I took them apart tonight.
::
:: I intend on dropping them and filling with epoxy then
:: drilling them out to install back to normal.
::
:: In examining them, I discovered there is a small area of
:: deck rot. About 4 x 3 inches to the aft. My question is
:: this:
::
:: Do I drill a series of holes and fill with epoxy as I do
:: the work mentioned above, or do I cut the top layer of
:: deck off and rebuild the core?
::
:: I am putting the boat in the water in 8 days so any
:: quick info is very much appreciated.
::
:: Thanks

:: Don

Reply | Post New Message | All Messages | this message is spam